First of all, you need to buy high-quality AB glue from a building material store. This glue consists of two glues, A glue and B glue, and the two glues are mixed in a ratio of one to one.
Next, you need a piece of No. 300 water matte paper.
Finally, prepare a utility knife.
Be prepared to sand the area on the skateboard that needs to be repaired with sandpaper and blow it clean. Start to adjust the glue, not too much, because the glue dries quickly, and the glue will start to harden in about 3 minutes. After adjusting the glue, use the plastic sheet that comes with the glue to pick up the glue and apply it on the board. Do not apply too thick one layer. After it dries, adjust the glue and continue to apply the glue until the glue is slightly thicker than the deck. Use a utility knife to repair it. Click the glue after it dries. After repairing, sand it carefully with sandpaper. In this way, your board will be repaired perfectly.
This kind of AB glue is more wear-resistant, even if it is worn off, it can be easily repaired by the above method.
In addition, the ratio of glue A to glue B. If the ratio of glue A is too high, there will be some braking feeling when the tail of the board is rubbed.
If the ratio of B glue is too high, the glue will be a bit brittle. Generally speaking, the ratio of AB is only one to one.
